How To Fix A Toilet
Have a look inside the tank. If the water level rises over the overflow tube, then the problem may be with the float or the valve. Remember that the float rises with the level of the water and tells the inlet valve when to shut the flow off. If this mechanism doesn't work properly, the water keeps rising until it spills through the overflow tube and into the bowl (Image 1). To check the inlet valve, flush the toilet and, like the water rises, gently lift the rod that holds the float (Image 2) until you hear the water stop. The inlet valve is OK, if the water stops, and the float causes the issue.
A screw at the peak of the ballcock allows you to adjust the level of the float. With this adjustment, you need to be able to decrease the level to which the water rises in the tank. The issue may be with the float itself, if the adjustment fails to stop water from running into the overflow tube. For instance, if the float has a hole in it and lies low in the water, it never rises the inlet valve. Check to find out whether the float requires replacing. A pole and float are easy to replace and cost only a couple bucks.
Turn Off the Water
The water doesn't stop and if the valve is tested by you as described above, the issue is with the ballcock itself. Though it's possible to repair a ballcock that is broken, it's usually best to replace the Entire assembly:
Flush the toilet, after turning the water off at the shutoff valve and hold the handle to remove the majority of the water from the tank down. Remove at the base of the tank with a sponge.
Replace the Assembly
Remove the supply line that connects to the base of the ballcock at the base of the tank (Image 1). Use pliers to remove the nut securing the ballcock.
Pushing up from the bottom, lift out the assembly (Image 2).
Drop the new ballcock assembly into place. Thread on a new nut from underneath this link the tank, and tighten with slip-joint pliers. (Don't overtighten the nut, or you could crack the tank.) Reattach the supply line.
Inside the tank, clip the new refill tube in place (Image 3). Turn the water on at the shutoff.
Evaluation the Flapper
If you have checked the water level and it is not rising above the overflow tube but you hear or view water flow into the bowl, the next source of the leak is around the flapper. Testing for this is simple: switch the water supply at the shutoff valve offwait to see if the amount in the tank falls. If it drops apparently after about 15 minutes, the problem might be a flapper chain that is too tight, so preventing the flapper.
The first step is to drain the tank.
Switch off the water at the shutoff valve, flush the toilet and hold down the handle. There could possibly be a small water left in the tank's bottom, but don't be concerned about it.
Wipe the flapper seat with a clean cloth to make sure it's free of debris, and check it for cracks or splits
Examine the flapper to make sure it's not torn and that it fits. Pull it loose if the flapper is worn or damaged and replace it. Pop a flapper onto the hinges at the Bottom of the overflow tube
Putting in a New Toilet
Most toilets come in 2 boxes: one to the bowl along with one to your own tank with all the components .
The measures show the way exactly to install the toilet and also just how to assemble the tank and bowl. You then attach the tank and may install the bowl initially. You can detach the tank from the bowl, in case the existing toilet is heavy. Maintain your back straight and lift with the legs. Order to get a helper if possible. Follow the actions if your bathroom is leaking out of the base and also you have to restore the wax ring.
You may install a standard, strain-, or bathroom. The rough-in distance -- that the measurement from mounting holes into the wall and the drain centre -- is 1 2 inches for some toilets. Some are 10 in.. Gauge the bathroom and purchase a new one together with precisely the same dimensions.
How To Fix A Toilet